Dumps Moneyack Guarantee - HPE6-A72 Dumps UpTo 50% Off [Q45-Q61]

Share

Dumps Moneyack Guarantee - HPE6-A72 Dumps UpTo 50% Off

Updated Oct-2021 Pass HPE6-A72 Exam - Real Practice Test Questions

NEW QUESTION 45
Refer to the exhibit.

Traffic is failing between Core-1 and Host-B. IP addressing has correctly been applied, and all interfaces are attached to the vrf GREEN.
Which configuration will correct the issue?

  • A. Core-1(config)# ip route 10.1.20.0/24 10.1.1.2 vrf GREEN Host-B: assign the default-gateway address 10.1.20.181
  • B. Core-2(config)# ip route 0.0.0.0/0 10.1.1.1 vrf GREEN Host-B: assign the default-gateway address 10.1.20.181
  • C. Host-B: assign the default-gateway address 10.1.20.181
  • D. Core-1(config)# ip route 10.1.20.0/24 10.1.1.2 vrf GREEN Host-B: assign the default-gateway address 10.1.20.1

Answer: A

 

NEW QUESTION 46
Refer to the exhibit

Which command on Access-2 port 1/1/4 will enable connectivity between PC-1 and Server-1 without any routing enabled in the network?

  • A. Access-2 (config-if-1/1/4)# vlan access 20
  • B. Access-2 (config-if-1/1/4)# vlan trunk allow 1, 10, 255
  • C. Access-2 (config-if-1/1/4)# vlan access 1, 10, 20, 255
  • D. Access-2 (config-if-1/1/4)# vlan 20 untag 1/1/4

Answer: A

 

NEW QUESTION 47
The section in blue can be ignored.
SW1(config)# interface 1/1/1-1/1/2
SW1(config-if-<1/1/1-1/1/2)# vlan access 2
SW1(config-if-<1/1/1-1/1/2)# exit
SW1(config)# interface 1/1/11-1/1/17
SW1(config-if-<1/1/11-1/1/17)# vlan access 17
SW1(config-if-<1/1/11-1/1/17)# exit
After completing the above commands, what is the expected output of show vlan with no other vlan commanded having been added?

  • A. Option D
  • B. Option B
  • C. Option A
  • D. Option C

Answer: A

 

NEW QUESTION 48
Refer to the exhibit.

Traffic is failing between Core-1 and Host-B. IP addressing has correctly been applied, and all interfaces are attached to the vrf GREEN.
Which configuration will correct the issue?

  • A. Core-1(config)# ip route 10.1.20.0/24 10.1.1.2 vrf GREEN
    Host-B: assign the default-gateway address 10.1.20.1
  • B. Host-B: assign the default-gateway address 10.1.20.181
  • C. Core-2(config)# ip route 0.0.0.0/0 10.1.1.1 vrf GREEN
    Host-B: assign the default-gateway address 10.1.20.181
  • D. Core-1(config)# ip route 10.1.20.0/24 10.1.1.2 vrf GREEN
    Host-B: assign the default-gateway address 10.1.20.181

Answer: D

 

NEW QUESTION 49
Match each network protocol to the correct default listening port and transport protocol. Not all answers will be used.

Answer:

Explanation:

 

NEW QUESTION 50
What are the commands to disable SSH and HTTPS services from the default VRF?

  • A. Core-1(config)# no ssh server
    Core-1(config)# no https-server
  • B. Core-1(config)# no ssh server vrf default
    Core-1(config)# no https-server vrf default
  • C. Core-1# no ssh server vrf default
    Core-1# no https-server vrf default
  • D. Core-1(config)# no ssh server enable
    Core-1(config)# no https-server enable

Answer: B

 

NEW QUESTION 51
Match the term to the correct description.

Answer:

Explanation:

 

NEW QUESTION 52
What are the benefits of a 3-Tier design over a 2-Tier? (Choose two.)

  • A. Lowering the cost of a deployment due to needing less switches overall.
  • B. Better scalability in a campus with a large number of buildings.
  • C. Offloading processing from the Core without routing at the Access layer.
  • D. Can use lower speed links between Core to Aggregation and Aggregation to Access given the use of an Aggregation layer.
  • E. Gaining the flexibility to connect the Data-Center to any Access layer switch.

Answer: B,C

 

NEW QUESTION 53
Review the exhibit.
As the frame traverses from **PC-1** to **Server-1**, the VLAN tag will be removed.
Click on the interface (circled in green) where the VLAN tag will be removed.

Answer:

Explanation:

 

NEW QUESTION 54
You need to remote into an AOS-CX switch using SSH in order to update the management IP address for future connections. Unfortunately, you mis-configured the IP address and are now locked out of the switch.
What command could you have issued before making changes that would have recovered the original switch configuration after ten minutes?

  • A. checkpoint auto confirm 10
  • B. boot system secondary 10
  • C. checkpoint auto 10
  • D. checkpoint rollback 10

Answer: C

 

NEW QUESTION 55
Match the available stacking feature to the correct AOS-CX switch model. Stacking features may be used more than once.

Answer:

Explanation:

 

NEW QUESTION 56
The section in blue can be ignored.
SW1(config)# interface 1/1/1-1/1/2
SW1(config-if-<1/1/1-1/1/2)# vlan access 2
SW1(config-if-<1/1/1-1/1/2)# exit
SW1(config)# interface 1/1/11-1/1/17
SW1(config-if-<1/1/11-1/1/17)# vlan access 17
SW1(config-if-<1/1/11-1/1/17)# exit
After completing the above commands, what is the expected output of show vlan with no other vlan commanded having been added?

  • A.
  • B.
  • C.
  • D.

Answer: A

 

NEW QUESTION 57
Refer to the exhibit.

You are in the process of configuring VSF between Access-1 and Access-2. Access-1 has been configured as the VSF Master.
What is a valid configuration for Access-2 to join the VSF stack?

  • A. Access-2# configure
    Access-2(config)# vsf member 2 Access-2(vsf-member-1)# link 2 1/1/28 Access-2(vsf-member-1)# exit This will save the VSF configuration and reboot the switch. Do you want to continue (y/n)? y
  • B. Access-2# configure
    Access-2(config)# vsf member 2 Access-2(vsf-member-1)# link 1 1/1/28 Access-2(vsf-member-1)# exit This will save the VSF configuration and reboot the switch. Do you want to continue (y/n)? y
  • C. Access-2# configure
    Access-2(config)# vsf member 1 Access-2(vsf-member-1)# link 1 1/1/28 Access-2(vsf-member-1)# exit Access-2(config)# vsf renumber-to 2 This will save the VSF configuration and reboot the switch. Do you want to continue (y/n)? y
  • D. Access-2# configure
    Access-2(config)# vsf member 1 Access-2(config)# vsf renumber-to 2 Access-2(vsf-member-1)# link 2 2/1/28 Access-2(vsf-member-1)# exit This will save the VSF configuration and reboot the switch. Do you want to continue (y/n)? y

Answer: B

 

NEW QUESTION 58
Refer to the exhibit.

Switch-1 is not the root bridge. The ports shown are all the connected pointtopoint interfaces. What Role (hidden by the blue rectangle) will be assigned to the Lag 1 interface?

  • A. Designated
  • B. Root
  • C. Alternate
  • D. Backup

Answer: B

 

NEW QUESTION 59
Click on the colored box that corresponds with the line that best represents Multicast traffic flow.

Answer:

Explanation:

Explanation:
Blue Box

 

NEW QUESTION 60
Which option correctly describes a WAN network?

  • A. the connection between two separate buildings in the same campus
  • B. compute resources that are networked locally over wireless
  • C. a group of computer resources that communicates between geographically separate location
  • D. a network of devices over long distances but limited to within a single ISP

Answer: C

 

NEW QUESTION 61
......


Exam Topics for Aruba Certified Switching Associate (HP HPE6-A72) Professional Exam

The following will be practiced in HP HPE6-A72 practice exam and HP HPE6-A72 practice tests:

  • IP Routing
  • ArubaOS-CX Management mechanisms
  • Fundamentals of the Network
  • Secure Administration & Maintenance
  • IP Routing - Section 3
  • Spanning Tree Protocol
  • Stacking
  • Link Aggregation
  • TCP/IP Stack
  • VLANs
  • Fundamental Networking by Aruba Solutions

 

Download Free HP HPE6-A72 Real Exam Questions: https://www.dumpsquestion.com/HPE6-A72-exam-dumps-collection.html

Pass Your Exam With 100% Verified HPE6-A72 Exam Questions: https://drive.google.com/open?id=1BhcNeynYoYNxTvTYt7iFcqqDmthjA1Hy