HPE6-A66 Dumps PDF - HPE6-A66 Real Exam Questions Answers
Get Started: HPE6-A66 Exam [2023] Dumps HP PDF Questions
Certification Completion
Three to five days after you complete all requirements, you receive an email notification. Then your status in The Learning Center becomes “acquired”.
If you renewed this certification through a recertification path, you will also recertify any lower level certifications you achieved within the same domain. Example: Renewal of ACMX will renew ACMP and ACMA. All renewed certifications from the one renewal path will have the same new expiration date.
If you renewed this certification by completing the Edge certification or the Edge recertification path at any level (Associate/Professional/Expert), this will renew all certifications you achieved at that same level and any lower levels you have achieved. Example: ACEP renews ACMP, ACSP, ACCP, ACDP etc. and any Associate level you already achieved. All renewed certifications from the Edge certification or recertification path will have the same new expiration date.
The HP HPE6-A66 exam, also known as the Aruba Certified Design Associate (ACDA) exam, is designed for individuals who want to demonstrate their knowledge and skills in designing enterprise-level wireless networks. This certification validates the candidate's ability to design Aruba wireless solutions based on customer requirements and industry best practices. Passing this exam is a requirement for obtaining the Aruba Certified Design Associate (ACDA) certification.
NEW QUESTION # 28
A network architect will be using VisualRF to determine the appropriate wireless coverage for a new wireless design. Seamless, uninterrupted roaming is necessary for this design, since voice will need to be supported. Given these requirements, which information should be used in VisualRF to plan a cost effective solution that meets these requirements?
- A. Minimum -70db, 1 AP per 2,500 square feet, capacity design
- B. Minimum -80db, 1 AP per 1,000 square feet, very high-density design
- C. Minimum -70db. 1 AP per 5,000 square feet, high density design
- D. Minimum -65db, 1 AP per 2,500 square feet, high density design
Answer: D
NEW QUESTION # 29
A network architect is doing a site survey for a new wireless design One concern the company has with the old wireless network is coverage. In some cases, APs would lose power and some employees in the network would lose wireless connectivity. The new design needs to prevent this issue from occurring. During the site survey, what are best practices to be followed in regards to the dBm signal level and the power of the AP to ensure adequate wireless coverage and minimal overlap of AP signals for the new design?
- A. AP power at 75% and a measurement of -90 dBM on the measuring device
- B. AP power at 75% and a measurement of -80 dBM on the measuring device
- C. AP power at 50% and a measurement of -65 dBM on the measuring device
- D. AP power at 100% and a measurement of -65 dBM on the measuring device
Answer: D
NEW QUESTION # 30
A customer requires Aruba switches that support Smart Rate ports to connect to Aruba APs Which switching product should the customer purchase that will provide 24 Smart Rate ports per access layer switch'?
- A. Aruba 2930M
- B. Aruba 2930F
- C. Aruba 2540
- D. OfficeConnect 1950
Answer: A
NEW QUESTION # 31
A network architect is redesigning a wireless network. The architect begins by analyzing the number of spatial streams supported by APs of various vendors as well as the wireless devices currently in the network, if the company wants to ensure that new wireless design, including user wireless devices, support Multi-User MIMO (MU-MIMO). which standard or standards must the wireless products support?
- A. Only 802.11ax,802.1lac, and 802.l1n
- B. Only 802.11ax
- C. Only 802.11ax and 8011.ac
- D. Only 802.11ax,802.11ac, 802.11n, and 802.11a
Answer: A
NEW QUESTION # 32
A university department has a program in video processing and editing. Students in the department use Wi-Fi to interact with the video servers. The editing and processing is done by the students accessing and using the video servers. However, the students must then stream their results, via Wi-Fi to their laptops to verify the results. A network architect has determined that no more than 20 APs will be needed for the Wi-Fi solution. Because of the large amount of bandwidth used during the streaming, the Aruba mobility controller solution will need to support 10 Gbps links.
Which solution would cost-effectively meet this customer's requirements?
- A. 0
- B. 1
- C. 7240XM
- D. 2
Answer: A
NEW QUESTION # 33
A high-end theater venue will be implementing an Aruba wireless solution using ceiling- and wall-mounted APs. The venue wants to ensure the the APs blend into the ceiling and wall environments. What solution should the customer use to ensure that wireless coverage is not hampered?
- A. Place the APs above the ceiling and behind the walls
- B. Order Aruba AP covers for the APs
- C. Paint the APs to match the ceilings or walls
- D. Place a strip of tape over the LEDs
Answer: A
NEW QUESTION # 34
A network architect is creating a new wireless solution for a customer. Wireless coverage is required throughout all four floors of two buildings on the same campus. Dynamic RF capabilities, including AirMatch, are required. Seamless roaming is required within and between the two buildings. Each floor will have approximately 20 APs and 6 external APs are required for connectivity between the two buildings.
- A. A standalone 7008 controller per floor
- B. Two 7030 mobility controllers in a cluster
- C. Given this information, which Aruba solution would be the most cost-effective while still meeting the customer's requirements? O An IAP cluster per floor
- D. Two 7205 mobility controllers in a cluster
Answer: C
NEW QUESTION # 35
When a WLAN has to support nomadic devices, a network architect must primarily plan for which component in their design?
- A. type of users
- B. mobility requirements and usage
- C. number of users per location
- D. density of users
Answer: B
NEW QUESTION # 36
Which feature does the Aruba AP 555 support? (Select two.)
- A. 802.11ac and lower standards only
- B. desk wall plate mounted
- C. high density indoor locations
- D. weather proof and temperature hardened
- E. three radios
Answer: A,C
NEW QUESTION # 37
Which type of Aruba AP uses its radio as its back-haul connection?
- A. Remote AP (RAP)
- B. Mesh Porta
- C. Air Monitor (AM)
- D. Mesh Point
Answer: B
NEW QUESTION # 38
NewRocket requires a wireless capacity design 30 Aruba 510 APs will be connected to each wiring closet using SmartRate connections. Wireless coverage needs to be provided even if a POE+ switch loses power Because of security concerns, wired video cameras were recently installed throughout the facility. There are 12 of these per floor. 6 per wiring closet. The cameras are 802.11n WiFi capable and have power injectors from which to draw power.
Based on the POE+ needs of the mentioned devices, which solution would meet the POE+ requirements while still providing a redundant and cost-effective Wi-Fi solution for the devices that require POE+ for Building 1, Floor 2?
- A. One 2930M 48-port POE+ switch
- B. One 3810M 40G 8 HPE Smart Rate switch
- C. Two 2930F 24-port POE+ switches
- D. Two 2930M 24-port POE+ switches
Answer: A
NEW QUESTION # 39
A company has two buildings on a campus that are approximately 700 feet (214 meters) apart with a clear line of site. No fiber exists between the buildings; however, there is a need for connecting the networks in the buildings together. The connection between the two buildings will need to support peak rates over 1 Gbps.
Which solution should the company choose that will meet their requirements as well as being cost-effective?
- A. Two outdoor AP 367s
- B. Two outdoor AP 387s
- C. Two outdoor AP 510s
- D. Multi-mode fiber between campus switches
Answer: A
NEW QUESTION # 40
A company has a warehouse that requires ruggedized APs to provide wireless access The APs need to support these characteristics:
* 2 or more spatial streams
* 802.11 ac and 802.11 n support
Cat 7 Ethernet cabling will be used to connect the APs to POE+ capable switches Link aggregation should be employed between the APs and the Ethernet switches. Which would be the most cost-effective solution that would meet the company's requirements?
- A. AP 318 with external omnidirectional antennas
- B. AP 365 with integrated omnidirectional antennas
- C. AP 510 with external omnidirectional antennas and plastic AP cover
- D. AP 375 with external omnidirectional antennas
Answer: A
NEW QUESTION # 41
A company needs to replace an existing legacy wireless and wired solution with one that supports features like 802 11 ax for APs and logical switching for switches. The company is located on a single floor with two wiring closets. Assume that there will be 10 APs connected via POE+ to each wiring closet, along with 36 wired user connections All switches on a floor should be configured in a single stack. The distance between wiring closets is 100 feet (31 meters).
Which switching solution will minimally provide 10 Gbps uplinks at the most cost-effective price, while still meeting the company's requirements?
- A. 2930F switches
- B. 2930M switches
- C. 5406R switches
- D. 3810M switches
Answer: B
NEW QUESTION # 42
Which IRIS option will automatically create a project with a blank preconfigured Site-1 ?
- A. New Campus
- B. New Project
- C. New Site
- D. New Express Mode
Answer: A
NEW QUESTION # 43
A network architect has developed a design for a new Aruba Wi-Fi network that will include a virtual Mobility Master (MM) running the ArubaOS 8.4 operating system that will manage:
* Two clustered 7210 controllers with 600 campus APs
* Two clustered VMC-50 controllers with 75 remote APs
* Wireless IPS
The architect plans on creating user roles and firewall policies on the controllers as well as implementing AirMatch. What would meet the license requirements for this scenario?
- A. LIC-MM-VA-1000 (X1), LIC-MC-VA-50 (x1), LIC-AP (x600). PEF (X600), RFP (x600)
- B. LIC-MM-VA-1000 (X1). LIC-MC-VA-50 (X1), LIC-AP (x675). PEF (X675), RFP (X675)
- C. LIC-MM-VA-50 (X1), LIC-MC-VA-50 (x2). LIC-AP (X675), PEF (x675), RFP (X675)
- D. LIC-MM-VA-1000 (X1), LIC-MC-VA-50 (x2), LIC-AP (X675). PEF (X675). RFP <x675)
Answer: B
NEW QUESTION # 44
A company needs an upgrade of its access layer switches. The solution requires that devices connected to the access layer by authenticated and their traffic processed by the firewall features of the Aruba Mobility Controllers. Which solution should the company implement?
- A. PAPI mobility
- B. GRE tunneling
- C. Dynamic segmentation
- D. iPsec tunneling
Answer: D
NEW QUESTION # 45
What is the main key for a network design to ensure users have a good experience running their applications'?
- A. Provision adequate bandwidth.
- B. Provide appropriate AP density.
- C. Determine the number of users per location.
- D. Implement appropriate security controls
Answer: B
NEW QUESTION # 46
A customer requires a campus core virtualization solution that supports a dual control and management planes, as well as active-active forwarding paths. Which solution would meet the customer's requirements?
- A. Mesh stacking
- B. Backplane stacking
- C. VSF
- D. VSX
Answer: B
NEW QUESTION # 47
NewStellar has a main corporate campus in a business park with two adjacent buildings that are 150 feet apart (46 meters). This is an open campus with no obstructions between the two buildings Each building has three floors and each floor is 322 x 175 feet (98 x 53 meters) for 56,350 square feet (5,235 square meters) total, which results in a total of 338,100 feet (31,410 square meters) for the entire building space. The ceiling for each floor is 12 feet (3.6 meters) high with a drop-down ceiling at 10 feet (3 meters) The network architect has given one floor to analyze. Building 1 Floor 2, shown in the attached exhibit.
This floor has a central main corridor with washrooms, stairs, elevators and supply, and network cabinets. There are cubicles around the perimeter of the floor. The central part main corridor's dimensions contain 9,350 square feet (870 square meters).
The company has determined that Wi-Fi coverage will not include the central area of each floor, which includes the washrooms, stairs, elevators and supply and network cabinets. Based on a capacity design, approximately how many APs should a network architect add to each floor to plan the design in VisuaiRF?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: D
NEW QUESTION # 48
......
HPE6-A66 Premium Exam Engine pdf Download: https://www.dumpsquestion.com/HPE6-A66-exam-dumps-collection.html
Verified HPE6-A66 Bundle Real Exam Dumps PDF: https://drive.google.com/open?id=1HaSOq-9XByfp_UOTZEhm0Vce0vgE-Ew4