[Jan-2022] H35-560 Dumps are Available for Instant Access using DumpsQuestion
H35-560 Dumps 2022 - New Huawei H35-560 Exam Questions
NEW QUESTION 19
LTE can obtain various interface signaling through LMT, M2000, and drive test tools.
- A. True
- B. False
Answer: A
NEW QUESTION 20
Which of the following descriptions are correct for cross-zone coverage? (Multiple choice)
- A. Cross-area coverage may result in unbalanced load between the cross-covered base station and surrounding base stations, resulting in low resource utilization of surrounding base stations
- B. Over-area coverage may form "islands", leading to dropped calls
- C. For LTE, cross-area coverage will not cause interference to its neighboring cells
- D. Cross-area coverage may cause UE transmit power limitation, causing access failure
Answer: A,B,D
NEW QUESTION 21
Which of the following access preamble formats supports the largest cell radius?
- A. Format2
- B. Format3
- C. Format0
- D. Format4
Answer: B
NEW QUESTION 22
Regarding TA planning, which of the following statements is incorrect?
- A. Each single carrier cell can belong to multiple Tas
- B. The TA plan of LTE should be consistent with the LA plan of 2G/3
- C. The number of cells in the TA of LTE should be smaller than the number of cells in the corresponding LA of 2G/3G
- D. Currently TAL of LTE can contain up to 16 TAs
Answer: C
NEW QUESTION 23
In mobile communication systems, there are usually two ways to define/obtain KPL: eNodeB performance statistics and drive test tools for drive test.
- A. True
- B. False
Answer: A
NEW QUESTION 24
In the LTE system, the mobility KPI is used to evaluate the mobility performance of the E-LTTRAN network. It directly reflects the quality of the user experience. Which of the following is not a mobility KPI?
- A. The success rate of switching out (same frequency/different frequency)
- B. Call establishment success rate
- C. Switch in success rate
- D. Success rate of switching out different systems
Answer: B
NEW QUESTION 25
The SINR of each codeword can be obtained through the Probe drive test tool, and the higher the SINR, the better.
- A. True
- B. False
Answer: A
NEW QUESTION 26
What are the evaluation methods for overlapping coverage issues? (Multiple choice)
- A. RSRP of the strongest cell-RSRP of the 3rd strongest (or 4th strongest) cell<3dBo
- B. The number of cells with RSRP>-100dBm is greater than or equal to 3.
- C. RSRP of the strongest cell-RSRP of the 3rd strongest (or 4th strongest) cell<6dBo
- D. The number of cells with RSRP>-100dBm is greater than or equal to 2.
Answer: B,C
NEW QUESTION 27
Which of the following adjustment measures has the highest priority?
- A. Antenna type
- B. Antenna direction angle antenna downtilt angle
- C. Antenna height
Answer: A
NEW QUESTION 28
In the case of FTP download or upload (or packet filling) without manual intervention, the throughput rate should be maintained at this time. If there is a sudden drop, call drops may occur.
- A. True
- B. False
Answer: A
NEW QUESTION 29
Which of the following is not a weak coverage solution?
- A. Adjust the antenna azimuth and downtilt angle, increase the antenna height, and replace the high-altitude wire, etc.
- B. Adjust neighbor relations
- C. adjusteNodeBTransmit power
- D. Check whether the room sub-system or repeater is working normally, and check whether there is other radio interference
Answer: B
NEW QUESTION 30
Which of the following format files can the Log file be converted to? (Multiple choice)
- A. The extension is .docx file
- B. The extension is .dlf fil
- C. The extension is .csv and the test data is separated by a separator (such as a comma, a semicolon, a period, etc.) in the exported text file.
- D. The extension is .gen and can be imported directly into the Probe.
Answer: B,C,D
NEW QUESTION 31
Before the cluster optimization test, the target area must be divided into clusters. Which of the following statements are correct? (Multiple choice)
- A. Refer to the existing cluster division for network engineering maintenance
- B. Make full use of the terrain (mountains and rivers)
- C. The cluster division should span different areas of the test (planning) full coverage business
- D. When dividing the cluster, the drive test in each cluster can be completed in one day, usually about 6 hours for one drive test
Answer: A,B
NEW QUESTION 32
When doing PCI planning, what principles need to be met? (multiple choice)
- A. Avoid cells with overlapping coverage areaspcimold3same
- B. Of all the districtsPCIAll different
- C. Cells that meet the reuse degreePCICan be the same
- D. Need for cells with overlapping coverage areasPCImold3same
Answer: A,C
NEW QUESTION 33
The A3 or A4 event is used for LTE inter-system handover.
- A. False
- B. True
Answer: A
NEW QUESTION 34
The main work content of single site verification includes: site verification configuration, site coverage verification, site business verification and handover relationship optimization.
- A. False
- B. True
Answer: A
NEW QUESTION 35
Which of the following factors are the base station receiver sensitivity related to? (multiple choice)
- A. Cell radius
- B. untieThreshold
- C. channelbandwidth
- D. Base station noise figure
Answer: B,C,D
NEW QUESTION 36
In the downlink scheduling, which factors will affect the allocation of downlink shared resources and the selection of MCS? (Multiple Choice)
- A. UE capability level
- B. Cache status
- C. The wireless environment where the user is located
- D. PHR (power headroom report) of UE
Answer: A,C
NEW QUESTION 37
......
Huawei H35-560 Exam Practice Test Questions: https://www.dumpsquestion.com/H35-560-exam-dumps-collection.html