NSE7_SDW-6.4 Free Update With 100% Exam Passing Guarantee [2021]
[Sep-2021] Verified Fortinet Exam Dumps with NSE7_SDW-6.4 Exam Study Guide
NEW QUESTION 10
What would best describe the SD-WAN traffic shaping mode that bases itself on a percentage of available bandwidth?
- A. Per-IP shaping mode
- B. Reverse policy shaping mode
- C. Shared policy shaping mode
- D. Interface-based shaping mode
Answer: C
NEW QUESTION 11
Refer to exhibits.
Exhibit A.
Exhibit B.
Exhibit A shows the SD-WAN performance SLA and exhibit B shows the SO-WAN interface and the static routes configuration.
Port1 and port2 are member interfaces of the SD-WAN, and port2 becomes a dead member after reaching the failure thresholds Which statement about the dead member is correct?
- A. SD-WAN interface becomes disabled and port1 becomes the WAN interface
- B. Dead members require manual administrator access to bring them back alive
- C. Port2 might become alive when a single response is received from an SLA server
- D. Subnets 100 .64-1.0/23 and 172 . 20 . 0. 0/16 are reachable only through port1
Answer: A
NEW QUESTION 12
Refer to the exhibit.
Which statement about the command route-tag in the SD-WAN rule is true?
- A. It uses route tags for a BGP community and assigns the SD-WAN rules with same tag.
- B. It enables the SD-WAN rule to load balance and assign traffic with a route tag
- C. It ensures route tags match the SD-WAN rule based on the rule order
- D. It tags each route and references the tag in the routing table.
Answer: C
NEW QUESTION 13
Refer to exhibits.
Exhibit A.
Exhibit B.
Exhibit A shows the SD-WAN performance SLA and exhibit B shows the SO-WAN interface and the static routes configuration.
Port1 and port2 are member interfaces of the SD-WAN, and port2 becomes a dead member after reaching the failure thresholds Which statement about the dead member is correct?
- A. Subnets 100 .64.1.0/23 and 172 . 20 . 0. 0/16 are reachable only through port1
- B. Dead members require manual administrator access to bring them back alive
- C. Port2 might become alive when a single response is received from an SLA server
- D. SD-WAN interface becomes disabled and port1 becomes the WAN interface
Answer: A
NEW QUESTION 14
What is the lnkmtd process responsible for?
- A. Flushing route tags addresses
- B. Monitoring links for any bandwidth saturation
- C. Logging interface quality information
- D. Processing performance SLA probes
Answer: B
NEW QUESTION 15
Which statement reflects how BGP tags work with SD-WAN rules?
- A. BGP tags match the SD-WAN rule based on the order that these rules were installed.
- B. VPN topologies are formed using only BGP dynamic routing with SD-WAN
- C. Route tags are used for a BGP community and the SD-WAN rules are assigned the same tag
- D. BGP tags require that the adding of static routes be enabled on all ADVPN interfaces
Answer: A
NEW QUESTION 16
What is the lnkmtd process responsible for?
- A. Logging interface quality information
- B. Monitoring links for any bandwidth saturation
- C. Flushing route tags addresses
- D. Processing performance SLA probes
Answer: A
NEW QUESTION 17
Refer to exhibits.
Exhibit B.
Exhibit A shows the firewall policy and exhibit B shows the traffic shaping policy.
The traffic shaping policy is being applied to all outbound traffic however inbound traffic is not being evaluated by the shaping policy Based on the exhibit, what configuration change must be made in which policy so that traffic shaping can be applied to inbound traffic'?
- A. The guaranteed-10mbps option must be selected as the per-IP shaper option
- B. A new firewall policy must be created and SD-WAN must be selected as the incoming interface.
- C. The guaranteed-10mbps option must be selected as the reverse shaper option.
- D. The reverse shaper option must be enabled and a traffic shaper must be selected
Answer: C
NEW QUESTION 18
Refer to exhibits.
Exhibit A shows the firewall policy and exhibit B shows the traffic shaping policy.
The traffic shaping policy is being applied to all outbound traffic; however, inbound traffic is not being evaluated by the shaping policy.
Based on the exhibits, what configuration change must be made in which policy so that traffic shaping can be applied to inbound traffic?
- A. The guaranteed-10mbps option must be selected as the per-IP shaper option
- B. A new firewall policy must be created and SD-WAN must be selected as the incoming interface.
- C. The guaranteed-10mbps option must be selected as the reverse shaper option.
- D. The reverse shaper option must be enabled and a traffic shaper must be selected
Answer: C
NEW QUESTION 19
Refer to exhibits.
Exhibit A shows the performance SLA exhibit B shows the SD-WAN diagnostics output.
Based on the exhibits, which statement is correct?
- A. SD-WAN member interfaces are affected by the SLA state of the inactive interface.
- B. The SLA state of port1 is dead after five unanswered requests by the SLA servers.
- C. Port1 became dead because no traffic was offload through the egress of port1.
- D. Both SD-WAN member interfaces have used separate SLA targets.
Answer: B
NEW QUESTION 20
Which statement defines how a per-IP traffic shaper of 10 Mbps is applied to the entire network?
- A. The 10 Mbps bandwidth is shared equally among the IP addresses.
- B. A single user uses the allocated bandwidth divided by total number of users.
- C. Each IP is guaranteed a minimum 10 Mbps of bandwidth.
- D. FortiGate allocates each IP address a maximum 10 Mbps of bandwidth.
Answer: D
Explanation:
Explanation/Reference:
https://docs.fortinet.com/document/fortigate/6.2.0/cookbook/885253/per-ip-traffic-shaper
NEW QUESTION 21
Refer to the exhibit.
Which two statements about the status of the VPN tunnel are true? <Choose two )
- A. FortiGate created a single IPsec virtual interface that is shared by all clients
- B. 100.64.3.1 is one of the remote IP address that comes through index interlace 1.
- C. VPN static routes are prevented from populating the FortiGate routing table
- D. There are separate virtual interfaces for each dial-up client
Answer: D
NEW QUESTION 22
Refer to the exhibit.
Based on the output shown in the exhibit, which two criteria on the SD-WAN member configuration can be used to select an outgoing interface in an SD-WAN rule? (Choose two.)
- A. Set cost 15.
- B. Set source 100.64.1.1.
- C. Set load-balance-mode source-ip-ip-based.
- D. Set priority 10.
Answer: B
NEW QUESTION 23
An administrator is troubleshooting VoIP quality issues that occur when calling external phone numbers. The SD-WAN interface on the edge FortiGate is configured with the default settings, and is using two upstream links. One link has random jitter and latency issues, and is based on a wireless connection.
Which two actions must the administrator apply simultaneously on the edge FortiGate to improve VoIP quality using SD-WAN rules? (Choose two.)
- A. Configure an SD-WAN rule to load balance all traffic without VoIP.
- B. Place the troublesome link at the top of the interface preference list.
- C. Select the corresponding SD-WAN balancing strategy in the SD-WAN rule.
- D. Choose the suitable interface based on the interface cost and weight.
- E. Use the performance SLA targets to detect latency and jitter instantly.
Answer: C,E
NEW QUESTION 24
Refer to the exhibit.
What must you configure to enable ADVPN?
- A. The protected subnets should be set to address object to all (0.0 .0. o/o).
- B. ADVPN should only be enabled on unmanaged FortiGate devices.
- C. On the hub VPN, only the device needs additional phase one sett
- D. Each VPN device has a unique pre-shared key configured separately on phase one
Answer: D
NEW QUESTION 25
Refer to exhibits.
Exhibit A.
Exhibit B.
Exhibit A shows the source NAT global setting and exhibit B shows the routing table on FortiGate Based on the exhibits, which two statements about increasing the port2 interface priority to 20 are true? (Choose two )
- A. All the existing sessions will continue to use port2 and new sessions will use port1
- B. All the existing sessions will be blocked from using port1 and port2
- C. All the existing sessions with no SNAT will start using port1 as the outgoing interface instead of port2
- D. All the existing sessions using SNAT will start using port1 as the outgoing interface instead of port2.
Answer: C,D
NEW QUESTION 26
Which diagnostic command you can use to show interface-specific SLA logs for the last 10 minutes?
- A. diagnose sys virtual-wan-link health-check
- B. diagnose sys virtual-wan-link intf-sla-log
- C. diagnose sys virtual-wan-link sla-log
- D. diagnose sys virtual-wan-link log
Answer: C
Explanation:
Explanation/Reference: https://docs.fortinet.com/document/fortigate/6.2.0/cookbook/943037/sla-logging
NEW QUESTION 27
Refer to exhibits.
Exhibit A shows the source NAT global setting and exhibit B shows the routing table on FortiGate.
Based on the exhibits, which two statements about increasing the port2 interface priority to 20 are true? (Choose two.)
- A. All the existing sessions will be blocked from using port1 and port2.
- B. All the existing sessions using SNAT will be flushed and routed through port1.
- C. All the existing sessions will continue to use port2, and new sessions will use port1.
- D. All the existing sessions that do not use SNAT will be flushed and routed through port1.
Answer: B,C
NEW QUESTION 28
Refer to the exhibit.
Which statement about the trace evaluation by FomGate is true?
- A. The packet exceeded the configured bandwidth and was dropped based on the priority configuration
- B. The packet exceeded the configured maximum bandwidth and was dropped by the shared shaper.
- C. Packets exceeding the configured concurrent connection limit are dropped based on tfte priority configuration.
- D. Packets exceeding the configured maximum concurrent connection limit are denied by the per-IP shaper.
Answer: C
NEW QUESTION 29
An administrator is troubleshooting VoIP quality issues that occur when calling external phone numbers The SD-WAN interface on the edge FortiGate is configured with the default settings, and is using two upstream links One link has random jitter and latency issues and is based on a wireless connection Which two actions must the administrator apply simultaneously on the edge FortiGate to improve VoIP quality using SD_WAN rules?
- A. Configure an SD-WAN rule to load balance all traffic without VoIP.
- B. Place the troublesome link at the top of the interface preference list.
- C. Select the corresponding SD-WAN balancing strategy in the SD-WAN rule.
- D. Choose the suitable interface based on the interface cost and weight.
- E. Use the performance SLA targets to detect latency and jitter instantly.
Answer: C,E
NEW QUESTION 30
Which diagnostic command can you use to show the SD-WAN rules interface information and state?
- A. diagnose sys virtual-wan-link member.
- B. diagnose sys virtual-wan-link neighbor.
- C. diagnose sys virtual-wan-link service
- D. diagnose sys virtual-wan-link route-tag-list
Answer: A
NEW QUESTION 31
Which statement defines how a per-IP traffic shaper of 10 Mbps is applied to the entire network?
- A. The 10 Mbps bandwidth is shared equally among the IP addresses.
- B. A single user uses the allocated bandwidth divided by total number of users.
- C. Each IP is guaranteed a minimum 10 Mbps of bandwidth
- D. FortiGate allocates each IP address a maximum 10 Mbps of bandwidth.
Answer: D
NEW QUESTION 32
Which statement about using BGP routes in SD-WAN is true?
- A. VPN topologies must be form using only BGP dynamic routing with SD-WAN
- B. Learned routes can be used as dynamic destinations in SD-WAN rules
- C. Adding static routes must be enabled on all ADVPN interfaces.
- D. Dynamic routing protocols can be used only with non-encrypted traffic
Answer: A
NEW QUESTION 33
Which statement about using BGP routes in SD-WAN is true?
- A. Adding static routes must be enabled on all ADVPN interfaces.
- B. Learned routes can be used as dynamic destinations in SD-WAN rules
- C. Dynamic routing protocols can be used only with non-encrypted traffic
- D. VPN topologies must be form using only BGP dynamic routing with SD-WAN
Answer: B
NEW QUESTION 34
......
Authentic Best resources for NSE7_SDW-6.4 Online Practice Exam: https://www.dumpsquestion.com/NSE7_SDW-6.4-exam-dumps-collection.html
NSE7_SDW-6.4 Test Engine Practice Exam: https://drive.google.com/open?id=1w2clH_QybKN1lXD73vSQPSZDrBbxrvVF