Tested Material Used To NS0-183 Test Engine Exam Questions in here [Aug-2021]
Penetration testers simulate NS0-183 exam PDF
NEW QUESTION 16
While preparing for a new cluster installation, your customer indicates that they have some disk shelves and switches that were discontinued at their old site. They want to re-use as much of this equipment as possible. You must verify that their discontinued equipment is compatible with the new equipment they have on order.
Which two actions will accomplish this task? (Choose two.)
- A. Run the Cluster Configuration Builder tool (ConfigBuilder).
- B. Verify compatibility from Activity IQ.
- C. Use the Hardware Universe portal (HWU).
- D. look up the compatibility in the Interoperability Matrix Tool (IMT).
Answer: C,D
NEW QUESTION 17
You are preparing for a new installation. While determining the most suitable version of ONTAP software to deploy, you want to verify the ONTAP 9 release cadence to ensure that you are deploying a Long Term Service (LTS) release.
In this scenario, where would you find this information?
- A. Visit the Hardware Universe site.
- B. Visit the NetApp Support site.
- C. Visit the ONTAP 9 Documentation Center site.
- D. Visit the Interoperability Matrix Tool site.
Answer: C
NEW QUESTION 18
You have just finished installing and configuring an ONTAP cluster for a customer.
In this scenario, which product collects information and produces site documentation?
- A. Active IQ OneCollect
- B. Inventory Collect Tool
- C. SnapGathers
- D. NetAppDocs
Answer: D
NEW QUESTION 19
An administrator is installing a new AFF A220 HA pair and needs to convert two unified target adapter (UTA) ports from converged network adapter (CNA) to FC.
In this scenario, which action sequence will accomplish this task?
- A. 1. Set the adapter to status-admin down. 2. Set the port mode to fc. 3. Set the adapter to status-admin up. 4. Reboot the node.
- B. 1. Set the adapter to status-admin down. 2. Reboot the node. 3. Set the port mode to fc. 4. Set the adapter to status-admin up.
- C. 1. Set the port mode to fc. 2. Set the adapter to status-admin down. 3. Reboot the node. 4. Set the adapter to status-admin up.
- D. 1. Set the adapter to status-admin down. 2. Set the port mode to fc. 3. Reboot the node. 4. Set the adapter to status-admin up.
Answer: D
NEW QUESTION 20
While troubleshooting an issue with a newly installed system, you used the system controller environment show command.
In this scenario, which issue would be diagnosed with this command?
- A. controller version issues
- B. controller configuration issues
- C. controller hardware issues
- D. shelf cabling issues
Answer: C
NEW QUESTION 21
After a storage failover, you notice that a NAS LIF, that is linked to the broadcast domain CIFS, is no longer reachable after the takeover. Node cluster1-01 is still waiting for giveback.
Referring to the exhibit, what caused the problem?
- A. Port a0a of node cluster1-01 is down.
- B. The ports of cluster1-02 are missing in the broadcast domain.
- C. The LIF has to be configured with a failover group.
- D. The broadcast-domain MTU needs to be either 1500 or 9000.
Answer: D
NEW QUESTION 22
After you install a new cluster with ONTAP 9.5 software, you want to create a new broadcast domain. During the creation of the broadcast domain, you receive an error that there are no free ports available.
What is the reason for this error message?
- A. By Default, all ports are bound to the "Default" broadcast domain. To create a new port, remove the needed ports from the "Default" broadcast domain and create a new IPspace.
- B. Before you configure a new broadcast domain, you should create a new IPspace.
- C. You can create a new broadcast domain only within the CLI.
- D. By Default, all ports are bound to the "Default" broadcast domain. To create a new port, remove the needed ports from the "Default" broadcast domain.
Answer: D
NEW QUESTION 23
Click the Exhibit button.
You have an 8-node cluster, and sometimes the data LIFs fail over to a non-working port.
Referring to the exhibit, what must you do to solve this problem?
- A. Configure more than one IPspace.
- B. Configure the MTU consistently across the cluster.
- C. Configure the LIFs using separate home nodes.
- D. Configure the correct Ethernet ports in all broadcast domains.
Answer: B
NEW QUESTION 24
Click the Exhibit button.
After you install a FAS2720 with ONTAP 9.5, you disconnect the management port of node A to demonstrate cluster management LIF failover to the custom. When you reconnect the management port and try to revert the interface, you receive the following message.
Info: LIF "cluster_mgmt" has been hosted on port "NetApp-Cluster-01:e0M", whosehealth status is degraded.
You issue the network port showcommand and see the output shown in the exhibit. When you try to access the cluster interface, you cannot ping or connect to the cluster through the network.
Which two troubleshooting steps must you perform to solve the issue? (Choose two.)
- A. Reconnect the management cable to bring the port online.
- B. Set the Ignore Health Status parameter to true.
- C. Set the Ignore Health Status parameter to false.
- D. Use the network port modify -up-admin command to administratively down and up the port.
Answer: A,D
NEW QUESTION 25
What are two ONTAP storage efficiency technologies that would be used on an AFF A400 cluster?
(Choose two.)
- A. FlexClone volumes
- B. FlashCache
- C. thin provisioning
- D. Flash Pool
Answer: B,D
NEW QUESTION 26
Which statement about LIFs is true?
- A. A data LIF can be associated with multiple SVMs.
- B. One cluster-management LIF exists per node.
- C. Cluster LIFs and data LIFs can share a port.
- D. One port can host multiple data LIFs.
Answer: D
NEW QUESTION 27
You want to verify that connections are cables correctly and that shelf IDs are unique within an HA pair.
Which tool would be used to accomplish these tasks?
- A. Active IQ Config Advisor
- B. System Diagnostics
- C. Cloud Insights
- D. Active IQ Unified Manager
Answer: B
NEW QUESTION 28
Before installing an 8-node cluster for a customer, you want to validate compatibility with existing hardware.
Which two tools would you use to validate the configuration? (Choose two.)
- A. Active IQ System Manager
- B. Interoperability Matrix Tool
- C. Active IQ Config Advisor
- D. Hardware Universe
Answer: B,C
NEW QUESTION 29
You just installed two nodes into an existing ONTAP cluster.
When running date on the CLI you notice that the cluster1-03 node is running behind time. You confirmed that you can reach the node management LIF of each node.
Referring to the exhibit, which statement is true?
- A. The NTP is adjusting in small increments.
- B. The node-management LIF has to be on e0M for NTP to work.
- C. The DNS is not configured for this node.
- D. No NTP server is configured for this node.
Answer: C
NEW QUESTION 30
When you set up a new 2-node switchless cluster running ONTAP 9.5, which IP subnet is used for the automatic IP assignment on cluster ports?
- A. 169.254.0.0/16
- B. 192.168.1.0/24
- C. 10.10.0.0/16
- D. 10.0.0.0/8
Answer: A
NEW QUESTION 31
A customer has a current AFF ASA A700 cluster and they want to expand the cluster by adding a second AFF ASA A700 HA pair.
In this scenario, which step would be required to accomplish this task?
- A. Install a Brocade FC switch and create zoning between the original cluster and the new cluster.
- B. Enable ALUA between the two HA pairs to allow cluster backend traffic.
- C. Install a BES-53248 cluster switch and convert the AFF ASA A700 from a switchless to switch cluster.
- D. The customer will need to create a separate cluster for the second AFF ASA A700 pair.
Answer: C
NEW QUESTION 32
After a storage failover, you notice that a NAS LIF, that is linked to the broadcast domain CIFS, is no longer reachable after the takeover. Node cluster1-01 is still waiting for giveback.
Referring to the exhibit, what caused the problem?
- A. Port a0a of node cluster1-01 is down.
- B. The ports of cluster1-02 are missing in the broadcast domain.
- C. The LIF has to be configured with a failover group.
- D. The broadcast-domain MTU needs to be either 1500 or 9000.
Answer: D
NEW QUESTION 33
......
Authentic Best resources for NS0-183 Online Practice Exam: https://www.dumpsquestion.com/NS0-183-exam-dumps-collection.html